U2631 BMW Fault Code

Description:

Throttle Position (TP) Sensor Intermittent The TP sensor circuit is monitored by the PCM for sudden BMW TP rotation angle (or voltage) input change through the comprehensive component monitor (CCM). If during the last 80 warm-up cycles in key ON engine running the BMW PCM detects a TP rotation angle (or voltage) changes beyond the minimum or maximum calibrated limit, a continuous diagnostic trouble code (DTC) is stored. Poor continuity through the TP sensor connectors Poor continuity through the TP harness Intermittent open or short inside the TP sensor While accessing the TP V PID on the scan tool, lightly tap on the TP sensor or wiggle the TP sensor connector and harness.

U2631 Code Symptoms :

If your U2631 check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U2631 and engine control unit are in charge of monitoring a bunch of different , and if they get a reading that's a little out of whack, up pops the check engine light.

Diagnosis And Repairing U2631

U2631 OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to fix U2631 code ?

• Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
• Damaged camshaft position (CMP) sensor
• Exhaust tube
• Open circuits caused by corrosion of electrical connectors.

As long as the throttle plate remains closed, the idling speed and quality is controlled by the PCM via the idle control valve, and as can be seen from the above it should be clear that idle control on a gasoline engine is a complex affair.

For instance, if the engine is started in sub-zero temperatures, the PCM will command the idling control valve to allow less air to enter the engine to enrich the air/fuel mixture to create a condition which is roughly analogous to how chokes worked on carburetted engines to control idling in cold weather.